Safety Meeting

Use full-spectrum LED lighting at around 400-600 µmol/m²/s for flowering, maintain 20-25°C with 40-50% RH, and ensure good air exchange to reduce mould risk in cooler UK summers.

Switch to a 12/12 light cycle for flowering and keep consistent timers. Avoid light leaks during the dark period to prevent stress and hermaphroditism.

A balanced feeding regime with slightly higher phosphorus and potassium during flowering supports bud development. Monitor EC and pH to avoid nutrient lockout in either soil or hydro setups.

Keep relative humidity below 50% in flower, increase air movement around colas and avoid overcrowding. Remove damaged leaves promptly and consider a dehumidifier if indoor humidity is persistently high.

Check trichomes and harvest when most are cloudy with some ambers for a balanced effect. Allow a short flush of plain water in the final week if growing in soil to improve smoke quality.

Yes, Safety Meeting responds well to topping, low stress training and SCROG to increase bud sites and even the canopy. Start training in vegetative stage and allow recovery before flowering.

Pests are a common issue but manageable with integrated pest management: sticky traps, beneficial insects and careful inspection. Keep the grow area clean and avoid bringing outside plants directly into the room without quarantine.

Many growers perform a short flush in the last week to ten days to reduce excess salts and improve taste. Flushing choice depends on medium and feeding schedule; monitor plant condition.

Dry slowly until stems snap rather than bend, then cure jars for at least two to four weeks for improved aroma and smoothness. Open jars daily for air exchange during the first week to prevent excess moisture.

Cannabis cultivation remains illegal without a licence in the UK, so check current legislation and obtain required permissions for research or medical growing. Be aware that penalties can be severe for unauthorised cultivation.